banner
Home>>News

Use and installation method of bathtub faucet

  • Edit:IBC faucet
  • Date:2022-03-28
  • Visits:1211
  • Sort:News

1. How to use the bathtub faucet

Close the drain valve tightly, and then start to drain water. The temperature can be adjusted by itself. After the water reaches its own requirements, pour in the bubble liquid and stir it properly, and it can be used.

2. Installation method of bathtub faucet

① Installation of single-hole basin faucet: When buying single-handle basin faucet, we should pay attention to the diameter of the outlet. It is understood that most of the water in the market now comes from hard pipes, so we should pay attention to the height of the reserved upper inlet, and it is most appropriate to work 35 minutes down from the basin. When installing, we must choose a special angle valve, which must be fixed with the hot and cold water pipes that come out of the wall. When there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it.

② Installation of thermostatic faucet: Before the thermostatic faucet, please check whether the water pipe is hot on the left and cold on the right, and remember not to connect the hot and cold water pipes by mistake, so as to prevent the faucet from working normally. Gas and solar water heaters can't use constant temperature faucets because the water pressure is too low. Please don't forget to install the hot and cold water filter when installing the thermostatic faucet.

③ Installation of shower and bathtub faucet (wall-hanging faucet) When you buy shower, bathtub and wall-hanging faucet, you can choose a suitable height to bury the outlet pipe, and the distance between hot and cold water pipes should reach 15cm. Don't forget to flush the water pipes before installation, so as to avoid the water quality being too good and causing damage to the faucet.

④ concealed shower and bathtub faucet: after purchasing concealed faucet, generally, the valve core of faucet should be embedded in the wall. Before embedding, we must pay attention to the thickness of the bathroom wall. If the wall is too thin, the valve core will not be embedded, and the plastic protective cover of the valve core should not be easily removed when embedding, so as to avoid damaging the valve core by cement and other chores. In addition, the residential online network reminds everyone to pay attention to the up-and-down and left-and-right directions of the valve core when embedding, so as to avoid the valve core being buried wrongly.


Copyright © 2023 IBC faucet All Rights Reserved.